What are the way to use multi -bag

The multi -bag filter uses a side -out method (can also use the method of bottoming out). The filtered liquid medium is pressed into or pumped into the barrel body of the multi -bag filter through the pressure in the pipe. The liquid medium is filtered by a filter bag supported by the filter through the perfusion of the electric polishing, which produces the ideal solid solution separation to achieve the liquid medium.

1. Filter element disinfection method

1. Take out the filter element from the plastic bag and put it in a 121 feet/minute disinfection cabinet. Disinfection for 30 minutes.

2 Filter element is installed in the filter according to the correct way (0.5mm interval between fixed board and filter element). Through the steam for 30 minutes

2. Identification

Multi -bag filter filter element can be carried out in the middle, and the front and backbone can be carried out in a different direction.

What are the way to use multi -bag

Third, pore recognition

The filter shell has a hot font style, and the filter element material and diameter are marked.

Fourth, filter element installation method

1 Wet the O -type circle and slowly insert the filter element vertically. All must be inserted into the stainless steel round groove.

2 Press the filter part of the wing piece with a stainless steel hole plate, and the pressure plate does not need to be too tight to prevent the filter element deformation when high temperature disinfection.

3 Avoid contact with the filter element directly by hand.

4 Rinse the filter element as much as possible before use.

5 When opening or closing, please open the valve slowly, do not open or turn off immediately, so as not to be sucked during the high temperature disinfection process.

5. Filter element maintenance method

When the multi -bag filter element cannot meet the design flow (the pressure table difference between the significantly decreases of the traffic is 0.1MPa), please open the filter and remove the filter from the filter, and rinse the surface dirt with water. Then soak for 24 hours of 4%hydrochloric acid, soak for 24 hours in 4%of sodium hydroxide, and then rinse with water (remove two O -type circles when soaking to prevent expansion).